Mazda RX-8 Workshop Manual page 1145

< Previous Next >
2011 - RX-8 - Engine
HIGH-TENSION LEAD REMOVAL/INSTALLATION [13B-MSP]
CAUTION:
Improper installation of the high-tension lead could result in a harmful electrical influence
of other electrical parts, or in a ground fault due to damage to the lead. Be sure to install
the lead in the same position and routing as when it is removed.
1. Remove the engine cover. (See
2. Remove the battery cover. (See
3. Disconnect the negative battery cable. (See
4. Remove the air hose (air cleaner to throttle body). (See
REMOVAL/INSTALLATION
5. Remove the high-tension lead from the ignition coil and the spark plug.
CAUTION:
1. Install the high-tension lead with blue and green tape on the trailing side.
6. Install in the reverse order of removal.
< Previous Next >
ENGINE COVER REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
[13B-MSP].)
© 2011 Mazda North American Operations, U.S.A.
BATTERY REMOVAL/INSTALLATION
INTAKE-AIR SYSTEM
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
Back to Top