Restoring The Modem To Factory Default Settings Section - Tadiran Telecom Emerald ICE Installation Manual

14.4
14-4
Emerald ICE HD Voicemail Installation Manual

Restoring the Modem to Factory Default Settings Section

If for some reason it becomes necessary to return the modem to it's original factory
default settings, follow these steps:
1. Connect the modem to the PC you will be using for the setup procedure
and power it on.
2. Start your communications program, making sure to use the correct port
assignment (COM1: COM2: , etc.)
3. Type AT&F0 and press
yet). You should see an "OK" response on the screen and now your typed
commands will show in the following steps.
4. Type AT&W0 and press
back into the modem as Profile 0
5. Type AT&Y0 and press
and the factory settings every time the modem is powered on.
The modem has now been reset to "out-of-the-box" condition.
Using the Modem
Cable Connection Procedures
Attach the modem through the PC programming port, using the terminal cable
(customer-supplied). There is a specific sequence to follow when attaching or
detaching these cable(s). This sequence MUST be followed to ensure proper
operation of the programming interface.
To connect to the PC terminal:
If the cable is currently connected to the modem and you now want to attach the
PC terminal, do the following IN ORDER:
1. Disconnect the card cable from the null modem/gender changer combo
cable.
2. Turn the modem power switch to OFF - all lights should go out.
3. Plug the card cable into the PC terminal's serial port.
4. Activate your terminal software and program as required.
R
(you will not see anything as you type
R
- this stores the factory default setting
R
- this tells the modem to load Profile 0