Modem Setup - Tadiran Telecom Emerald ICE Installation Manual

14.2
14-2
Emerald ICE HD Voicemail Installation Manual

Modem Setup

The modem that is to be used for programming REQUIRES a very specific set of
instructions to be sent to and stored in the modem. If these commands are not
programmed, the modem will answer but you WILL NOT be able to see the
Emerald ICE HD Voicemail system screens.
You will need to connect the modem to a regular PC to program the modem. Any
standard communications package will be able to perform the programming. Once
the programming has been completed, the modem will have these special
commands stored as the default configuration.
The modem will then only be able to be used with the Emerald ICE HD Voicemail
system unless it is reset to the original factory settings.
Follow the instructions below to set up your modem:
1. Connect the modem to the PC you will be using for the setup procedure
and power it on start your communications program, making sure to use
the correct port assignment (COM1: COM2: , etc.)
2. Type AT and press
modem. You should receive "OK" back as the response on the screen. If
the modem does not respond, check your modem documentation and
recheck all connections.
3. Once you can get the OK response, continue with the next section.
R
to verify the connection is working to the