Tadiran Telecom Emerald ICE Installation Manual page 142

13-8
Emerald ICE HD Voicemail Installation Manual
Setting Up the Local Emerald ICE HD Voicemail System
The Company Parameters Screen is used to set up the local Emerald ICE HD
Voicemail system for network node operation. The majority of the fields on this
screen were setup when the Emerald ICE HD Voicemail system was configured for
local operation, as described in Section 500, Initial Setup.
The Company Parameters Screen provides the following Networking fields:
Network Node - the network node number of the local Emerald ICE HD
Voicemail system.
Network Node Digits - The number of digits that a valid network node
number contains. (Note that a 1-digit node number permits 9 systems in the
network and a 2-digit nude number permits up to 99 systems. )
Network Enable In - A ʹYʹ in this field enables network messages to come in to
the local network node and an ʹNʹ disable network messages from coming in
to the local network node.
Network Enable Out - A ʹYʹ in this field enables network messages to be sent
out from the local network node and an ʹNʹ disables network messages from
being sent out from the local network node.
A class of service must be defined before it can be entered into the Site
Parameters screen.
C.O.S. - A three-digit code that references a predefined set of parameters used
to determine the outdial parameters applied to all outgoing network
messages. Outdial parameter information is programmed using the Outdial
Parameters Screen. (
Programming Steps
Based on information defined by the Networking Data sheet for this system,
modify the system parameters to support network operation by performing the
steps below:
a. From page one of the Main Menu, press 1 for ʹSite Administrationʹ. The
Site Administration Screen appears.
b. The Company Code field at the top of the screen shows ʹTADʹ as the
three-character company code. This field matches the Company field in the
Company Setup Screen. Make sure that the company code listed on the
screen and the Networking data sheet match. If these codes do not match,
there is a problem with the data definitions established for the network.
Contact the network coordinator named during network set up for
assistance in resolving this conflict. (Emerald ICE HD Voicemail is set by
default to TAD, so this should not be an issue)
!
-P from the Mailbox Administration screen)