Image Processor Performance; Input (Source Signal) Compatibility; Analog (Only) Input; Twin Hdmi Input - Christie Mirage M Series User Manual

7.3

Image Processor Performance

Min input pixel rate
Max input pixel rate
Max input resolution
Min input resolution
Max input frame rate with
Standard Image Processor
Card
Processing
Source switching time
7.4

Input (Source Signal) Compatibility

7.4.1 Analog (Only) Input

Connectors
Color spaces/signal types
A/D conversion

7.4.2 Twin HDMI Input

Connectors
Color spaces/signal types

7.4.3 Dual Link DVI Input

Connectors
Color spaces/signal types
A/D conversion
Frequency
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)
13 Mpix/s
330MHz over dual link DVI-D
2048x1536 (QXGA)
640x400
59Hz at 2560x1600 (QXGA) *
10 bit throughout *
Seamless switching with switch
time less than 1 second
* With sources that can output minimum
blanking, otherwise lower vertical rates
* Except Dual-DVI input in dual-link mode
(dual 8 bit input paths into 10 bit processing)
5 female BNC, 75 Ohm
R/Pr
G/Y
B/Pb
H/C
V
RGB
YPbPr
10 bits
2 independent HDMI inputs type A
2 loop-out connectors type A
RGB
YCbCr (4:2:2)
YCbCr (4:4:4)
HDCP support
HDMI 1.3 supported (not including audio) except:
12 bit color dithered to 10 bits; 16 bit color not
supported
1 dual link DVI-I, 300MHz
1 analog 15-pin VGA
NOTE: VGA is supported for mono signals or part
of a dual input 3D signal.
HDCP support
10 bits for single link DVI input
8 bits for dual link DVI inputs
165 MPixel/s analog
Section 7: Specifications
7-7