Table 9: Configuration Wizard Session - Dhcp - Mellanox Technologies TX6000 Hardware User Manual

Table 8 - Serial Terminal Program Configuration (Continued)
Flow Control
Login as admin and use admin as password. On the first login, the MLNX-OS configuration
Step 3.
wizard will start.
To configure network attributes and other initial parameters to the system, follow the configu-
Step 4.
ration wizard as shown in
Table 9 - Configuration Wizard Session - DHCP
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes
Step 1: Hostname? [switch ]
Step 2: Use DHCP on mgmt0
interface? [no] yes
Step 3: Enable IPv6? [yes]
Step 4: Enable IPv6 auto-config
(SLAAC) on mgmt0 interface?
[no]
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
21 Mellanox Technologies
Parameter
None
Table
Wizard Session Display
Setting
9.
You must perform this configuration the first time you operate the
system or after resetting the system. Type 'y' and then press
<Enter>.
If you wish to accept the default hostname, press <Enter>. Other-
wise, type a different hostname and press <Enter>.
Perform this step to obtain an IP address for the system. (mgmt0 is
the management port of the system).
If you wish the DHCP server to assign the IP address, type 'yes'
and press <Enter>.
If you type 'no' (no DHCP), then you will be asked whether you
wish to use the 'zeroconf' configuration or not.
If you enter 'no' (no Zeroconf), you must enter a static IP, and the
session will continue.
The management interface will be able to use IPv6 addresses.
This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
To enable DHCPv6 on the MGMT0 interface.
Comments
Installation