Table of Contents
Advertisement
InfiniBand Switch Platform Hardware User Manual
Check the mgmt0 interface configuration before attempting a remote (for example,
Step 5.
SSH) connection to the switch. Specifically, verify the existence of an IP address.
4.2
Re-Running the Wizard
To rerun the wizard:
Enter the config mode.
Step 1.
Rerun the wizard.
Step 2.
4.3
Downloading FabricIT Software and Documents
To download FabricIT software and documentation, please visit the following webpage:
http://www.mellanox.com/content/
pages.php?pg=ib_fabricit_efm_management&menu_section=55.
Mellanox Technologies
switch # show interfaces mgmt0
Interface mgmt0 state
Admin up:
yes
Link up:
yes
IP address:
169.254.15.134
Netmask:
255.255.0.0
IPv6 enabled:
yes
Autoconf enabled:
yes
Autoconf route:
yes
Autoconf privacy:
no
IPv6 addresses:
1
IPv6 address:
fe80::202:c9ff:fe11:a1b2/64
Speed:
1000Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
Interface source:
physical
MTU:
1500
HW address:
00:02:C9:11:A1:B2
Comment:
RX bytes:
11700449
RX packets:
55753
RX mcast packets: 0
RX discards:
0
RX errors:
0
RX overruns:
0
RX frame:
0
TX queue len:
1000
switch > enable
switch # config terminal
switch (config) # configuration jump-start
You need to enter the License Entitlement number and the switch S/N to obtain the
software and documentation, and also to generate an EFM license that enables
extended FabricIT management and inspection features on your switch system.
TX bytes:
15139846
TX packets:
28452
TX discards:
0
TX errors:
0
TX overruns:
0
TX carrier:
0
TX collisions: 0
75
Advertisement
Table of Contents
