Table of Contents
Advertisement
Rev 1.0
3. Connect the power cord.
4. Connect the data transfer cables.
3.3.2
Installation Procedure for a Side by Side Installation
No installation kit comes with this switch. The installation kit must be ordered separately. The
order number is MSX60-DKIT.
Installation kit parts for a side by side installation:
• 1 Two switch metal frame
• 4 switch mounting rails - The kit contains
enough rails to install 2 switches.
• 24 flat head screws - The kit contains
enough screws to install 2 switches.
• 10 spacer bushing for frame installation
The installation kits come with enough switch mounted rails and flat head screws to install two
switches.
The 2 switch frame will fit into racks with from 21" (533mm) to 34" (864mm) between the verti-
cal supports.
Installing the switch slides on the switch
1. Place the ESD mat on the floor where you will be working and put on the ESD strap. Make
sure the ESD strap is touching your skin and that the other end is connected to a verified
ground.
2. Screw the two switch mounted rails to the switch using six flat head screws per rail.
34
Mellanox Technologies
Figure 20: Installation Kit Parts for a Side by Side Installation
• 2 frame rail slides
• 10 M-5 Pan head screws
• 1 blank cover
• 4 rubber stick-on feet
Not used for side by side installation
Installation
Advertisement
Table of Contents
