Enabling The Tracker Pagers For Stations; Setting The Data Parameters - Comdial G0408 Manual

Digital Telephone System
3.20.3 Enabling Tracker Pagers For Stations
Description: After you have enabled the Tracker Paging System as a system-wide feature, enable the
Tracker pagers at individual stations. Station users can disable a Tracker Pager by
pressing INTERCOM #06 or enable a Pager by pressing INTERCOM 06.
To Program: 1. Dial 53.
2. Dial 37.
3. Enable Tracker pager operation
4. Press
To clear current setting, repeat procedure.
NOTE: The Pager's ID must be programmed to correspond to a DSU station
3.20.4

Setting The Data Parameters

Description: You must set the data parameters of the data port where you connect Tracker to 9600
baud, eight data bits, one stop bit, and no handshaking to ensure proper Tracker operation.
NOTE: The Tracker base station must also be programmed for 9600 baud so that it
To Program: 1. Dial 15.
2. Dial 1 for port A
3. Dial 0811 for data parameters.
4. Press
3 – 156 System Programming
—Dial 10–57 or press C10–C57 (LED On = Enabled).
for configuration mode.
number. Pager programming must be done through the Tracker base station.
Refer to the "Program Mode" section of IMI89–138, Operating Instructions
For The Tracker Paging System.
matches the DSU setting. The default Tracker base station baud setting is
9600; however, if you want to check or change the baud setting in the base
station, refer to section V, "Software Configuration," of 68P81101B25–O,
Alphanumeric Interface Option.
for configuration mode.
"STATION FEATURES"
"DISPLAY PAGER"
"BAUD RATE"
IMI66–107