Line Disable; Line Groups - Comdial G0408 Manual

IMI66–107
3.6.3

Line Disable

Description: You can take a line port out of service when necessary (because of defect or some other
reason) using this programming procedure.
To Program: 1. Dial 31.
2. Select line ports to be disabled.
3. Dial
To enable a disabled line, use the procedure described in section 3.6.6, Line Port
Functions, and program it as a central office line.
3.6.4

Line Groups

Description: Group outside lines of the same type together for dial-up outgoing access. Access codes
for the line groups are as follows:
—Group 1 = Dial 9
—Group 2 = Dial 81
—Group 3 = Dial 82
—Group 4 = Dial 83.
NOTE:
To Program: 1. Dial 35.
2. Dial 0 for no groups assigned
3. Select line ports to be assigned (LED On = Lines Assigned).
4. Dial
To change the settings, repeat procedure and make different selections.
—Line port 1–14 = Dial 01–14 or Press A1–A14
—Line port 15, 16 = Dial 15, 16 or press B1, B2
—Line port 17–24 = Dial 17– 24 or press HOLD then press A1–A8.
for configuration mode.
When you perform this procedure, the system automatically arranges itself
for hybrid operation. Remember, hybrid operation may incur a higher
monthly tariff than what the key system operation incurs. Ask the local
telephone company for details.
—OR—
—Dial 1 for Line Group 1
—Dial 2 for Line Group 2
—Dial 3 for Line Group 3
—Dial 4 for Line Group 4.
—Line port 1–14 = Dial 01–14 or press A1–A14
—Line port 15–16 = Dial 15–16 or press B1–B2
—Line port 17–24 = Dial 17–24 or press HOLD then press A1–A8.
for next group
—OR—
dial for next feature
—OR—
dial for configuration mode.
Digital Telephone System
"DISABLE LINES"
"ASSIGN LINE GRPS"
"NO LINE GROUP"
"LINE GROUP 1"
"LINE GROUP 2"
"LINE GROUP 3"
"LINE GROUP 4"
System Programming 3 – 39