Positive Disconnect Supervision; Voice Mail Pause - Comdial G0408 Manual

Digital Telephone System
3.14.6

Positive Disconnect Supervision

Description: When a station is on line with an outside caller and the caller hangs up, the CO may send
a positive disconnect signal to the DSU. You can enable the positive disconnect
supervision feature on a per-line basis. If you enable positive disconnect supervision,
when the system receives the CO's positive disconnect signal the system tells the voice
mail equipment to hang up.
To Program: 1. Dial 48.
2. Select line ports for disconnect supervision (LED On = lines selected to receive
3. Dial
3.14.7

Voice Mail Pause

Description: Some voice mail systems allow you to program a pause before they dial an extension
number. You can program the digital telephone system to pause before receiving digits
from a voice mail system. This capability allows the digital telephone system to match
the voice mail system's pause. If the voice mail system does not pause before dialing an
extension number, you must disable the fixed one second pause in the digital telephone
system.
To Program: 1. Press ITCM #746 .
2. Dial 17.
3. Dial 13.
4. Press A1 to toggle between VM pause on
5. Dial 1 for VM pause on.
6. Dial 2 for VM pause off.
3 – 112 System Programming
tables).
—Line port 1–14 = Dial 01–04 or press A1–A14.
—Line port 15, 16 = Dial 15, 16 or press B1, B2.
—Line port 17–24 = Dial 17–24 or press HOLD then press A1–A8.
for configuration mode.
and VM pause off (LED on = pause on).
"DIS. SUPERVISION"
"CONFIG. MODE"
"SYSTEM FEATURES"
"VM PAUSE XXX"
"VM PAUSE ON"
"VM PAUSE OFF"
IMI66–107