Voice Mail Port - Comdial G0408 Manual

IMI66–107
3.14.1

Voice Mail Port

Assign The Voice Mail Port
Description: When you connect the voice mail equipment to a common equipment station port either
through the ATI-D or directly to the port (depending upon the type of voice mail
equipment you are using), you must use the assign voice mail port feature to enable the
station port as a voice mail port. The assign voice mail port programming procedure only
applies to voice mail systems supported by Comdial's proprietary DTMF integration.
Once you perform this step, the station port will only emit DTMF tones (it will not emit
INTERCOM tones or ring-back tones).
NOTE: When you are interfacing voice mail equipment through an ATI-D device
To Program: 1. Dial 53.
2. Dial 32.
3. Select station ports to be programmed (LED On = Selected)
4. Dial
and you later replace the ATI-D with a proprietary digital multiline
telephone, the system automatically disables the port as a voice mail port;
however, if you disconnect the voice mail equipment from the ATI-D and
replace it with a model 2500 telephone, you must reprogram the station port
so that it is no longer programmed as a voice mail port.
—Station 10–57 = Dial 10–57 or press C10–C57.
for next feature
—OR—
dial for configuration mode.
Digital Telephone System
"STATION FEATURES"
"VOICE MAIL PORT "
System Programming 3 – 107