Comdial G0408 Manual page 274

Digital Telephone System
To Program: 1. Dial 08.
2. Choose the message style.
3. Select DVA station ports
4. Press # to end DVA station port entry.
5. Press 0 to erase all four messages.
6. Dial code for message type you wish to record
7. Record the messages using either step a or step b, described below. Note the length
8. Press 9 and repeat steps 6–7 for each message.
9. Dial code to listen to your recorded messages.
10. To record or play messages for another DVA, press
11. When finished, press SPEAKER to end.
NOTE: You should set a DISD dial time that is as long as the maximum time needed
3 – 162 System Programming
—Dial 1 for DISD message style.
—Dial 2 for DCD message style.
—Dial 10–57 or press C10–C57 (LED On = Selected).
—Dial 5 to record day answer message
—Dial 6 to record night answer message
—Dial 7 to record recall message
—Dial 8 to record drop message
—Dial 9 to stop recording.
of time for the message. Remember, the maximum allowed time for messages is two
minutes.
a. Read the message aloud into the telephone handset mouthpiece.
—OR—
b. Start the audio tape recorder and play the pre-recorded message.
—Dial 1 to play day answer message.
—Dial 2 to play night answer message.
—Dial 3 to play recall message.
—Dial 4 to play drop message.
—Dial 9 to stop playback.
to complete the longest DVA message. For example, if the longest DVA
message is 60 seconds, set the DISD dial time to 60 seconds. If the DISD dial
time is longer that the DVA message, the message will repeat itself. If the
DISD dial time is shorter than the DVA message, the message will not finish.
"DVA TABLE NUM"
"PORT NUMBER"
"PORT NUMBER"
"DVA MESSAGES"
and repeat steps 2–8.
IMI66–107