Message Display Time For Account Codes - Comdial G0408 Manual

Digital Telephone System
3.9.5

Message Display Time For Account Codes

Description: When you enable the account code feature, LCD speakerphones prompt users to enter an
account code with a displayed message that the system clears at the end of a
programmable display time. Use this procedure to set the length of time for the display
within the range of 1 to 20 seconds. (The default setting is 5 seconds.) If account codes
are forced, the system drops the line if the user fails to enter a valid account code during
the display period. You also can make this prompting message appear in the telephone
display when the user answers an incoming call. This prompting feature will remind
users to enter account codes for answered calls.
To Program: 1. Dial 75.
2. Dial 10.
3. Dial 1–20 to select new display time (in seconds).
4. Dial
To change setting, repeat procedure and make different selection.
Incoming And Outgoing Call Prompt For Account Code Entries
Description: You must enable or disable the account code message display time for both incoming and
outgoing calls.
To Program: 1. Dial 75.
2. Dial 11 for Incoming Calls
3. Press A1 to toggle feature on or off LED On = Enabled)
4. dials for configuration mode.
To change setting, repeat procedure and make opposite selection.
3 – 92 System Programming
for configuration mode.
—OR—
dial 12 for Outgoing Calls.
—OR—
dial 1 to enable
dial 2 to disable.
"SMDA PROGRAMMING"
"DISPLAY TIME X "
"SMDA PROGRAMMING"
"XXXXXXX INCOMING"
"XXXXXXX OUTGOING"
"ENABLE INCOMING"
"DISABLE INCOMING"
IMI66–107