Table of Contents
Advertisement
10.3 Show WDS Status
Peers MAC Address, antenna 0/1 received signal strength, phy mode and channel
bandwidth for each WDS are available.
10.3.1 MAC : Display MAC address of WDS peer.
10.3.2 Signal Strength ANT0/ANT1 : Indicate the signal strength of the repective WDS
linkes.
10.3.3 Phy Mode : Indicate the phy mode of the respective WDS linked.
10.3.4 BandWidth : Indicate the channel bandwidth of the respective WDS linked.
If display "no signal" Signal Strength ANT0/ANT1, you need check WDS
configuration. Things to verify are MAC Address, Channel and Security type.
Also, adjust antenna angle and Tx Power.
500mW eXtreme Power 11Na Outdoor Bridge
268
User's Manual
Advertisement
Table of Contents
