Cerio OW-200N2 User Manual page 185

7.1.2 Configure WAN Setup
There are three connection types for the WAN port : Static IP, Dynamic IP, PPPoE and PPTP,
Please click on System -> WAN and follow the below setting.
In CPE mode, the WAN Port is the Wireless interface.
Mode : By default, it's "Static IP". Check "Static IP", "Dynamic IP", "PPPoE" or "PPTP"to set up system WAN IP.
Static IP : Users can manually setup the WAN IP address with a static IP provided by WISP.
IP Address : The IP address of the WAN port; default IP address is 192.168.1.254
IP Netmask : The Subnet mask of the WAN port; default Netmask is 255.255.255.0
IP Gateway : The default gateway of the WAN port; default Gateway is 192.168.1.1
Dynamic IP : Please consult with WISP for correct wireless settings to associate with WISP AP before a
dynamic IP, along with related IP settings including DNS can be available from DHCP server. If IP Address is
not assigned, please double check with your wireless settings and ensure successful association. Also,
you may go to
"WAN
Information" in the Overview page to click Release button to release IP address and click Renew button to
renew IP address again.
500mW eXtreme Power 11Na Outdoor Bridge
185
User's Manual