Cerio OW-200N2 User Manual page 70

Destination Port : Specify destination port range required for this rule
Action : After configuring rule, a policy rule ensures that a traffic flow gets the requested treatment in the
network.
Remark DSCP : Specify a new DSCP class, if you want to replace or remark the DSCP
Bandwidth : Click "Enable" to activate function, and click "Disable" to deactivate function
Upload / Download : Specify the bandwidth in kilobit per second (Kbps). Enter a number between 8 to 8192,
default upload is 128 Kbps, download is 1024 Kbps.
Click "Add" button to add QoS rule to List. There are 10 rules maximum allowed in this QoS List. All rules can be
removed or edited on the List. Click Reboot button to activate your changes.
When you create rules on the QoS List, the previous rules have higher priority. . Below depict the examples for
explaining priority of QoS setup.
Example 1 : On this setting, the FTP has 1024 Kbps upload and 8196 Kbps download on 192.168.2.10. The
remaining IP address and other remaining protocol of IP address 192.168.2.10 only can use total bandwidth
512 Kbps bandwidth. Because rule 1's priority is higher than rule 2
Rule Source IP
1 192.168.2.10
2
Example 2 : On this setting, the FTP has 512 Kbps upload and 512 Kbps download on 192.168.2.10
Because rule 1's priority is higher than rule 2
Rule Source IP
1
2 192.168.2.10
500mW eXtreme Power 11Na Outdoor Bridge
Destination IP DSCP
ANY
ANY
Destination IP DSCP
ANY
ANY
Protocol Remark DSCP
FTP NO
ANY NO
Protocol Remark DSCP
ANY NO
FTP NO
70
User's Manual
Bandwidth (Up/Down)
1024/8196
512/512
Bandwidth (Up/Down)
512/512
1024/8196