Cerio OW-200N2 User Manual page 14

1.6.2.9 Setting for transmission speed
1.6.2.10 Dynamic Wireless re-transmission
1.6.2.11 IEEE802.11f IAPP (Inter Access Point Protocol), hand over users to
another AP
1.6.2.12 IEEE 802.11i Preauth (PMKSA Cache )
1.6.2.13 IEEE 802.11h - TPC(Transmission Power Control) and DFS(Dynamic
Frequency Select)
1.6.2.14 IEEE 802.11d -Multi country roaming
1.6.2.15 Wireless Site Survey
1.6.2.16 Channel Bandwidth setting: 20MHz or 20/40MHz
1.6.2.17 HT Tx/Rx Stream selection: 1 or 2
1.6.2.18 A-MSDU and A-MPDU support
1.6.2.19 Maximal MPDU density for TX aggregation setting
1.6.2.20 Short Slot support
1.6.2.21 RTS Threshold and Fragment Threshold support
1.6.3 Authentication/ Encryption (Wireless Security)
1.6.3.1 Layer 2 User Isolation and AP Isolation
1.6.3.2 Blocks client to client discovery within a specified VLAN
1.6.3.3 WEP 64/ 128 Bits
1.6.3.4 EAP-TLS + Dynamic WEP
1.6.3.5 EAP-TTLS + Dynamic WEP
1.6.3.6 PEAP/ MS-PEAP + Dynamic WEP
1.6.3.7 WPA (PSK +TKIP)
1.6.3.8 WPA (802.1x certification + TKIP)
1.6.3.9 802.11i WPA2 (PSK + CCMP/ AES)
1.6.3.10 802.11i WPA2 (802.1x certification + CCMP/ AES)
1.6.3.11 Setting for TKIP/ CCMP/ AES key's refreshing period
1.6.3.12 Hidden ESSID support
1.6.3.13 Setting for "Deny ANY " connection request
1.6.3.14 MAC Address filtering (MAC ACL)
1.6.3.15 No. of registered RADIUS servers: 1
1.6.3.16 VLAN assignment on ESSID
500mW eXtreme Power 11Na Outdoor Bridge
14
User's Manual