Table of Contents
Advertisement
AC_VO. When you do not click Checkbox, it means that the ACM is controlled
by the connecting AP. If you click Checkbox, it means that the Client is in
charge.
Change these settings as described here and click Save button to save your
changes. Click Reboot button to activate your changes. The items in this page
are for AP's RF advanced settings and will be applied to all WDS links.
6.5 Site Survey
Use this tool to scan and locate WISP Access Points and select one to associate with.
Please click on Wireless -> Site Survey. Below depicts an example for site survey.
6.5.1 ESSID : Available Extend Service Set ID of surrounding Access Points.
6.5.2 MAC Address : MAC addresses of surrounding Access Points.
6.5.3 Signal : Received signal strength of all found Access Points.
6.5.4 Channel : Channel numbers used by all found Access Points.
6.5.5 Security : Security type by all found Access Points.
6.5.6 Band : Wireless band used by all found Access Points.
6.5.7 Network Type : Network type used by all found Access Points.
6.5.8 Select : Click "Select" to configure settings and associate with chosen AP.
Notice: While clicking "Select" button in the Site Survey Table, the "ESSID" and
"Security Type" will apply in the Wireless General Setup. However, more settings
are needed including Security Key.
500mW eXtreme Power 11Na Outdoor Bridge
172
User's Manual
Advertisement
Table of Contents
