Table of Contents
Advertisement
7.2 Access Point Association
7.2.1 Configure Wireless General Setting
The administrator can change the data transmission, channel and output power settings for the system. Please click
on Wireless -> General Setup and follow the below setting.
Band Mode : Select an appropriate wireless band; bands available are 801.11aor 802.11a/n mixed mode.
Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from 6
to 54 Mbps for 802.11a
Country : Select the desired country code from the drop-down list; the options are US, ETSI, JP and NONE.
Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless
network. Specify digit number between 1 to 100 (the unit is %) for your environment. If you are not sure of which
setting to choose, then keep the default setting, 100%.
When Band Mode select in 802.11a only mode, the HT(High Throughput) Physical Mode and 11n Configuration
settings should be hidden immediately.
Operating Mode : By default, it's Mixed Mode.
Mixed Mode : In this mode packets are transmitted with a preamble compatible with the legacy 802.11a/g,
the rest of the packet has a new format. In this mode the receiver shall be able to decode both the Mixed
500mW eXtreme Power 11Na Outdoor Bridge
192
User's Manual
Advertisement
Table of Contents
