Table of Contents
Advertisement
6.3 Configure Wireless General Setting
The administrator can change the data transmission, channel and output power settings
for the system. Please click on Wireless -> General Setup and follow the below setting.
6.3.1 General Setup
6.3.1.1
Band Mode : Select an appropriate wireless band; bands available are
801.11aor 802.11a/n mixed mode.
6.3.1.2
Transmit Rate Control : Select the desired rate from the drop-down list;
the options are auto or ranging from 6 to 54 Mbps for 802.11a.
6.3.1.3
Tx Power : You can adjust the output power of the system to get the
appropriate coverage for your wireless network. Specify digit number between
1 to 100 (the unit is %) for your environment. If you are not sure of which
setting to choose, then keep the default setting, 60%.
6.3.2 HT Other
When Band Mode select in 802.11a/n mixed mode, the HT(High Throughput)
settings should be shown-up immediately.
6.3.2.1
HT TxStream/RxStream : By default, it's 2.
500mW eXtreme Power 11Na Outdoor Bridge
162
User's Manual
Advertisement
Table of Contents
