Mac Filter Setup - Cerio OW-200N2 User Manual

2.5.2 MAC Filter Setup

Allows to create MAC filter rules to allow or deny unicast or multicast packets from limited number of MAC addresses.
Important to note that MAC filter rules have precedence over IP Filter rules.
Please click on Advance -> MAC Filter Setup and follow the below setting.
MAC Filter Rule : By default, it's "Disable". Options are Disabled, Only Deny List MAC or Only Allow List
MAC. Click Save button to save your change.
Two ways to set the MAC Filter List:
Only Allow List MAC.
The wireless clients in the MAC Filter List will be allowed to access to Access Point; All others will be denied.
Only Deny List MAC.
The wireless clients in the MAC Filter List will be denied to access to Access Point; All others will be allowed.
MAC Address : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click "Add" button, then the MAC address
should display in the MAC Filter List.
There are a maximum of 20 clients allowed in this MAC Filter List. The MAC addresses of the wireless clients can be
added and removed to the list using the Add and Delete buttons.
Click Reboot button to activate your changes
500mW eXtreme Power 11Na Outdoor Bridge
64
User's Manual