Advanced Setup - Cerio OW-200N2 User Manual

increase error rate in some installations, due to increased sensitivity to
radio-frequency reflections. Select the option that works best for your installation.
3.4.6 MCS : This parameter represents transmission rate. By default (Auto) the fastest
possible transmission rate will be selected. You have the option of selecting the
speed if necessary.
3.4.7 Reverse Direction Grant(RDG) : Disable or enable reserve direction grant. Default
is enabled.
3.4.8 Extension Channel : When "20/40" channel bandwidth has been chosen, you should
select extension channel to get higher throughput.
3.4.9 A-MSDU : Aggregated Mac Service Data Unit. Select Enable to allow aggregation for
multiple MSDUs in one MPDU Default is disabled.
3.4.10 Auto Block ACK : Disable or enable auto block ACK. Default is enabled.
3.4.11 Decline BA Request : Disable or enable decline BA request. Default is disabled.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes. The items in this page are for AP's RF
general settings and will be applied to all VAPs.

3.5 Advanced Setup

To achieve optimal wireless performance, it is necessary to tweak advance setting per
requirements properly, not necessary higher the better or lower.
The administrator can change the RTS threshold and fragmentation threshold settings for
the system. Please click on Wireless -> Advanced Setup and follow the below setting.
500mW eXtreme Power 11Na Outdoor Bridge
91
User's Manual