Access Control List (Ip Filter Setup) - Cerio OW-200N2 User Manual

5.9 Access Control List (IP Filter Setup)

Allows to create deny or allow rules to filter ingress or egress packets from specific source
and/or to destination IP address on wired (LAN) or Wireless (WAN) ports.
Filter rules could be used to filter unicast or multicast packets on different protocols as
shown in the IP Filter Setup. Important to note that IP filter rules has precedence over
Virtual server rules. Please click on Advance -> IP Filter Setup and follow the below
setting.
5.9.1 Source Address/Mask : Enter desired source IP address and netmask; i.e.
192.168.2.10/32.Source Port : Enter a port or a range of ports as start:end; i.e. port
20:80
5.9.2 Destination Address/Mask : Enter desired destination IP address and netmask; i.e.
192.168.1.10/32
5.9.3 Destination Port : Enter a port or a range of ports as start:end; i.e. port 20:80
5.9.4 In/Out : Applies to Ingress or egress packets
5.9.5 Protocol : Supports TCP, UDP or ICMP.
500mW eXtreme Power 11Na Outdoor Bridge
149
User's Manual