Cerio OW-200N2 User Manual page 101

3.6.2 Virtual AP Setup
For each Virtual AP, administrators can configure SSID, VLAN tag(ID), SSID
broadcasting, Maximum number of client associations, security type settings.
Click Edit link on the Edit column, and then a Virtual AP setup page appears.
3.6.2.1 Enable AP : By default, it's "Disable" for VAP1 ~ VAP6. The Primary
AP(VAP0) always enabled.
Select "Enable" to activate VAP or click "Disable" to deactivate this function.
3.6.2.2 ESSID : Extended Service Set ID, When clients are browsing for available
wireless networks, this is the SSID that will appear in the list. ESSID will
determine the service type available to AP clients associated with the specified
VAP.
3.6.2.3 Client Isolation : Select Enable, all clients will be isolated from each other,
that means all clients can not reach to other clients.
3.6.2.4 Hidden SSID : By default, it's "Disable".
Enable this option to stop the SSID broadcast in your network. When disabled,
people could easily obtain the SSID information with the site survey software
and get access to the network if security is not turned on. When enabled,
network security is enhanced. It's suggested to enable it after AP security
settings are archived and setting of AP clients could make to associate to it.
3.6.2.5 Maximum Clients : The default value is 32. You can enter the number of
wireless clients that can associate to a particular SSID. When the number of
client is set to 5, only 5 clients at most are allowed to connect to this VAP.
500mW eXtreme Power 11Na Outdoor Bridge
101
User's Manual