Cisco 7941G Administration Manual page 125

Cisco Unified IP Phone Settings
Option
LLDP: PC Port
LLDP-MED: SW Port
LLDP Asset ID
Wireless Headset
Hookswitch Control
LLDP Power Priority
IP Addressing Mode
Description
Enables and disables Link Layer
Discovery Protocol (LLDP) on the PC
port. Use this setting to force the phone to
use a specific discovery protocol. Settings
include:
• Enabled—default
• Disabled
Enables and disables Link Layer
Discovery Protocol Media Endpoint
Discovery (LLDP-MED) on the switch
port. Use this setting to force the phone to
use a specific discovery protocol, which
should match the protocol supported by
the switch. Settings include:
• Enabled—default
• Disabled
Identifies the asset ID assigned to the
phone for inventory management.
Enables users to receive notifications of
incoming calls and answer or end calls
while working in a wireless environment.
Advertises the phone's power priority to
the switch, enabling the switch to
appropriately provide power to the phones.
Settings include:
• Unknown—default
• Low
• High
• Critical
Displays the IP addressing mode that is
available on the phone-IPv4 only, IPv6
only, or IPv4 and IPv6.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Network Configuration Menu
To Change
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > Common
Device Configuration.
Communications Manager 9.0 (SCCP and SIP)
105