Phone Setup Options - Cisco 7941G Administration Manual

Phone Setup Options

Related Topics
Display Settings Menu, on page 60
Unlock and Lock Options, on page 60
Phone Setup Options, on page 62
Network Configuration Menu, on page 64
Device Configuration Menu, on page 84
Security Configuration Menu, on page 108
Cisco Unified IP Phone Reset or Restore, on page 229
Phone Setup Options
The settings that you can change on a phone fall into several categories, as shown in the following table. For
a detailed explanation of each setting and instructions for changing them, see
on page
There are several options on the Network Configuration menu and on the Device Configuration Menu
Note
that are for display only or that you can configure from Cisco Unified Communications Manager. These
options are also described in this chapter.
Table 8: Settings Configurable from the Phone
Category
General Network Settings
VLAN settings
Port settings
IPv4 Network Settings
DHCP settings
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
62
64.
Description
Admin. VLAN ID allows you to
change the administrative VLAN
used by the phone. PC VLAN allows
the phone to interoperate with
third-party switches that do not
support a voice VLAN.
Allows you to set the speed and
duplex of the network and access
ports.
Dynamic Host Configuration
Protocol (DHCP) automatically
assigns IP address to devices when
you connect them to the network.
Cisco Unified IP Phones enable
DHCP by default.
Cisco Unified IP Phone Settings
Network Configuration Menu,
Network Configuration Menu Option
Admin. VLAN ID
PC VLAN
SW Port Configuration
PC Port Configuration
DHCP
DHCP Address Released