Cisco 7941G Administration Manual page 116

Media Configuration Menu
Option
Recording Tone
Recording Tone Local
Volume
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
96
Description
Indicates whether a recording tone is
enabled or disabled for the phone. If the
recording tone option is enabled, the
phone plays the beep tone in both
directions of every call, regardless of
whether the call actually gets recorded.
The recording tone first sounds when a
call is answered.
You may want to notify your users if
you enable this option.
Default: Disabled
Related Parameters:
• Recording Tone Local Volume
• Recording Tone Remote Volume
• Recording Tone Duration
Note Other related parameters:
the recording tone
frequency in hz, the
length of the recording
tone (called duration),
and how often the
recording tone plays
(called interval)—are
defined on a per-Network
Locale basis in the xml
file that defines tones.
This xml file is usually
named tones.xml or
g3-tones.xml.
Indicates the loudness setting for the
recording tone that is received by the
party whose phone has the recording
Tone option enabled.
This setting applies for each listening
device (handset, speakerphone,
headset).
Range: 0 percent (no tone) to 100
percent (same level as current volume
setting on the phone).
Default: 100
See Recording Tone in this table.
Cisco Unified IP Phone Settings
To Change
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.