Cisco Unified Ip Phones And Different Protocols; Convert New Phone From Sccp To Sip; In-Use Phone Protocol To Protocol Conversion; Deploy Phone In Sccp And Sip Environment - Cisco 7941G Administration Manual

Cisco Unified IP Phones and Your Network

Cisco Unified IP Phones and Different Protocols

The Cisco Unified IP Phones can operate with Skinny Client Control Protocol (SCCP) or Session Initiation
Protocol (SIP). You can convert a phone from using one protocol to using the other protocol.

Convert New Phone from SCCP to SIP

A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Step 1 Take one of these actions:
• To autoregister the phone, set the Auto Registration Phone Protocol enterprise parameter in Cisco Unified
• To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone
• To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
For more information on Cisco Unified Communications Manager configuration, see Cisco Unified
Communications Manager Administration Guide. For more information on using BAT, see Cisco Unified
Communications Manager Bulk Administration Guide.
Step 2 If you are not using DHCP in your network, configure the network parameters for the phone.
Step 3 Save the configuration updates, click Apply Config, click OK in the Apply Configuration Information window,
and have the user power cycle the phone.
Related Topics
Network Settings, on page 57

In-Use Phone Protocol to Protocol Conversion

For information on how to convert an in-use phone from one protocol to the other, see the Cisco Unified
Communications Manager Administration Guide, "Cisco Unified IP Phone Configuration" chapter, "Migrate
existing phone settings to another phone" section.

Deploy Phone in SCCP and SIP Environment

To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the Cisco
Unified Communications Manager autoregistration parameter specifies SCCP, perform these general steps:
Communications Manager Administration to SIP.
model and choose SIP from BAT.
window in Cisco Unified Communications Manager Administration.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Cisco Unified IP Phones and Different Protocols
Communications Manager 9.0 (SCCP and SIP)
41