Aastra 9000i Series Administrator's Manual page 385

For incoming intercom calls, an administrator or user can configure the following parameters:
Configuration File Parameters
• sip allow auto answer
• sip intercom mute mic
• sip intercom warning tone
• sip intercom allow barge in
Configuring Intercom Calls Settings
You can configure the Intercom feature using the configuration files or the Aastra Web UI.
Use the following procedures to configure Intercom calls on the IP phone.
Configuration Files
For specific parameters you can set in the configuration files for outgoing Intercom, see Appendix A, the
section, "Outgoing Intercom Settings"
For specific parameters you can set in the configuration files for incoming Intercom, see Appendix A, the
section, "Incoming Intercom Settings"
Aastra Web UI
Outgoing intercom settings
1 Click on Basic Settings->Preferences->Outgoing Intercom Settings.
2 Select an Intercom type for outgoing Intercom calls from the Type list box.
Valid values are Phone-Side, Server-Side, Off. Default is Off.
5-108
Note: To configure incoming intercom calls using these parameters, see
"Configuring Intercom Calls Settings"
Note: An administrator can configure the incoming and outgoing
Intercom feature. A user can configure the incoming Intercom feature
only.
on page A-183.
on page A-184.
Web UI Parameters
• Auto-Answer
• Microphone Mute
• Play Warning Tone
• Barge In
on page 5-108.
41-001343-01 Rev 02, Release 3.2.2