Pppoe Circuit Id Insertion Settings; Rcp Server Settings; Smtp Settings - D-Link xstack DES-3810 series Reference Manual

®
xStack

PPPoE Circuit ID Insertion Settings

When the setting is enabled, the system will insert the circuit ID tag to the received PPPoE discover and request
packet if the tag is absent, and remove the circuit ID tag from the received PPPoE offer and session confirmation
packet. The insert circuit ID will contain the following information: Client MAC address, Device ID and Port number.
By default, Switch IP address is used as the device ID to encode the circuit ID option.
To view the following window, click Network Application > PPPoE Circuit ID Insertion Settings, as shown below:
Click the Apply button to accept the changes made.

RCP Server Settings

This page is used to configure global RCP server information. This global RCP Server setting can be used when the
Server or remote user name is not specified. Only ONE RCP server can be configured per system. If user does not
specify the RCP Server in the CLI command, and global RCP Server was not configured, the Switch will ask user to
input the Server IP address or remote user name while executing the RCP commands.
To view the following window, click Network Application > RCP Server Settings, as shown below:
The fields that can be configured are described below:
Parameter
IP Address
User Name
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.

SMTP Settings

SMTP or Simple Mail Transfer Protocol is a function of the Switch that will send switch events to mail recipients based
on e-mail addresses entered in the window below. The Switch is to be configured as a client of SMTP while the server
is a remote device that will receive messages from the Switch, place the appropriate information into an e-mail and
deliver it to recipients configured on the Switch. This can benefit the Switch administrator by simplifying the
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 10-24 PPPoE Circuit ID Insertion Settings window
Figure 10-25 RCP Server Settings window
Description
The IP address of global RCP Server. By default, the server is unspecified.
The remote user name for logon into global RCP Server. By default, global server's
remote user name is unspecified.
372