Error Messages - Kyocera Mita FS-6750 Service Manual

Error messages

Table 6. 5
Message
Call service
Person####:0123456
Call service
PersonF###:0123456
Call service
PersonF0
File not found
Press GO
Format error
Memory Card
Format error
Hard disk
Hard disk error##
Press GO
I/F occupied
ID error
Corrective action
(Refer to 6.4 Diagnostic, page 6-11.)
(Refer to 6.4 Diagnostic, page 6-11.)
(Refer to 6.4 Diagnostic, page 6-11.)
VMB: A VMB tray that was specified for output does not
contain any jobs, or the VMB tray is not being used. Con-
firm the VMB tray. If Auto Continue is set to On, print-
ing will be automatically resumed after a preset period of
time. Refer to printer's User's Manual.
This message appears when the printer is in the ready
state and the memory card (CompactFlash) is not for-
matted, and therefore cannot be read or written. Refer to
printer's User's Manual.
Initialization (formatting) of the hard disk is required.
Initialize the hard disk (Microdrive). Refer to printer's
User's Manual.
Look at the error code given in place of ## and refer to
the corresponding description given below.
01 : Hard disk (Microdrive) format error. If this error
recurs even if the power has been turned off and then on,
reformat the hard disk.
02 : The disk system is not installed. Recheck the
requirements for using the system and the devices.
04 : There is no available hard disk (Microdrive) space.
Delete unnecessary files, etc., in order to free up space.
05 : The specified file does not exist in the hard disk
(Microdrive).
06 : There is no memory available to the hard disk
(Microdrive) system. Increase the available memory.
10 : Formatting is not possible because host data is being
spooled on the hard disk (Microdrive). Wait until the
hard disk is ready, and then format.
85 : VMB; Alias error (The alias setting was lost, or the
VMB tray corresponding to the alias does not exist.) Set
alias again.
97 : Code job; The number of permanent code job reached
the limit value, and no more can be saved. Either delete
some unnecessary jobs, etc., or increase the limit.
99 : A print job for the specified ID does not exist in the
hard disk (Microdrive).
This message is displayed when you attempt to use the
printer's operator panel to change the environmental set-
tings on the interface from which data are presently
being received.
The ID entered for a private job, or a stored job is not cor-
rect. Check the ID that is set using the printer driver.
6-8
Troubleshooting
General error handling
FS-6750