Message Operation; D Tx Message Programming - Icom IC-E92D Instruction Manual

7
DV MODE OPERATION

■ Message operation

D TX message programming

TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
, a to z
ters) (lower case letters)
q Enter "TX MESSAGE" in message/position set mode.
➪
❮MENU screen❯ ❮MESSAGE/POSITION❯
(Push [MENU/ ]) (Rotate [DIAL]
• TX MESSAGE screen is displayed.
w Rotate [DIAL]
†
to select the desired transmit message
channel.
• Ch01 to Ch05 and OFF are available.
• Previously message is displayed if programmed.
e Push [ ](6) to select the message edit condition.
• The 1st digit of the message blinks.
TX MESSAGE TX MESSAGE
r
:SET :SET
:BACK :BACK
52
, some symbols and space.
➪
❮TX MESSAGE❯
†
, then push [
Ch01 Ch01 AB
†
:SEL :SEL
:EDIT :EDIT
CLR:CLR CLR:CLR
r Rotate [DIAL]
• Push [A/a](3) to change the character group from "AB" (alpha-
betical characters; capital letters), "ab" (alphabetical characters;
(capital let-
lower case letters), "12" (numbers) and " !" " (symbols) in se-
quence.
• If an un-necessary character is entered, push [ ](6) or [ ](4)
to select the character, then push [CLR](1) to erase the se-
lected character, or push and hold [CLR](1) for 1 sec. to erase
‡
](5) .) all characters following the cursor.
t Push [ ](6) to select 2nd digit, then rotate [DIAL]
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
y Repeat the steps r and t to enter the desired message.
• Up to 20-character messages can be set.
u Push [ ](5) to store the message.
i Push [MENU/
†
to select the desired character or symbol.
TX MESSAGE TX MESSAGE
r Ch01 Ch01 !' !' '
Hello! Hello!†
:SET :SET CLR:CLR CLR:CLR
:SEL :SEL A/a:CHAR A/a:CHAR
:CUR :CUR
] to return to frequency indication.
†
to se-