Replacing The Processor - Fujitsu PRIMERGY RX330 S1 Service Supplement Manual

Replacing the processor

Ê Reinstall the hot-plug hard disk modules (for a detailed description see the
Operating Manual).
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
4.9 Replacing the processor
V
CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its socket,
place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Ê Open the server as described in the
Ê Remove the air duct as described in the
Figure 29: Disengaging the locking lever
Ê Press the two springs of the locking lever first somewhat downward and then
outward until they disengage.
38
section "Preparation" on page
section "Preparation" on page
Service Supplement
Replacement routines
17.
RX330 S1
17.