Installing Internal Scsi File Device - NEC Express5800 User Manual

Installing Internal SCSI File Device

To install the internal SCSI file device, you need prepare a separately priced SCSI controller and
SCSI cable.
IMPORTANT:
Up to two SCSI devices can be installed in the server.

To install two half-height SCSI devices in the 5.25-inch device bay,

move the factory-installed optical disk drive to the top bay.
SCSI controller: N8103-75F, N8103-95
SCSI cable: K410-68A(00) internal SCSI cable
K410-68A(00) internal SCSI cable is equipped with terminating resistor. Set "Disabled" for all the
terminating resistors of connected devices. For other setting, refer to the manual provided with the
device.
A file device needs settings such as a SCSI transfer rate. For the transfer rate, see the manual
provided with the file device. Use the BIOS utility of the SCSI controller to make the settings. For
details, see the manual provided with the SCSI controller.
Mother board
SCSI controller
SAS cable
K410-68A(00)
internal SCSI cable
RAID
controller
SATA cable for optical
disk drive
Internal Cabling Diagrams 10-3
Terminator
Optical disk drive
SCSI cable
(SCSI device)
5.25-inch
device bay
3.5-inch disk
cage
Hard disk
drives are
optional