NEC Express5800 User Manual page 481

Create from the menu which appears when running NEC Express5800 Server with
NEC EXPRESSBUILDER
If you have only NEC Express5800 server to create Windows Server 2008 OEM-Disk for
EXPRESSBUILDER, use this procedure.
If Windows Server 2008 can be operated on NEC Express5800 Server, you can use the other
procedure described later.
Follow the steps below.
1.
Prepare one Flash FDD, or one USB floppy disk drive and 3.5-inch floppy disk.
2.
Turn on your NEC Express5800 server.
3.
Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the server.
4.
Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may also
turn off and then on again to reboot the server.)
The system will boot from the DVD and NEC EXPRESSBUILDER starts.
5.
Select [Create the OEM-Disk for Windows] from [Tools Menu] step.
6.
Connect the Flash FDD or the USB floppy disk drive. (If you use the floppy disk drive,
insert a floppy disk into it.)
7.
Select [Create a Windows Server 2008 OEM-Disk for EXPRESSBUILDER] at [Create
OEM-Disk] and click [Perform].
NOTE:
(x64) Edition, select [Create a Windows Server 2008 x64 OEM-Disk
for EXPRESSBUILDER].
8.
Windows Server 2008 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
IMPORTANT: If you have created "OEM-Disk" into the Flash FDD,
disconnect it after the NEC EXPRESSBUILDER had been shut
downed.
NOTE:
write-protected.
Cancel write-protected state.
If you have already cancelled write-protected state, connect the floppy
disk drive again.
In case of creating the disk for Windows Server 2008 64-bit
If the following message is displayed, the floppy disk is
Installing Windows Server 2008 E-9