NEC Express5800 User Manual page 383

Installation (First 2.5-inch Disk Cage)
Install the 2.5-inch disk cage in the following procedure. If the 3.5-inch disk cage has already been
installed, you need to remove it first.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Release the lock of the front door by using the security key to open the front door.
3.
Remove the side cover.
4.
Disconnect all the cables from the rear of 3.5-inch disk cage.
NOTE:
connector, unlock it, then pull it out. Pulling the cable while holding the
cord harness may cause damage to the connector.
5.
Remove four screws from the 3.5-inch disk cage, and the four screws from the two
dummy covers. Then, remove the 3.5-inch disk cage and dummy covers.
NOTE:
You will need these screws to install the 2.5-inch disk cage.
To disconnect SGPIO cable or SAS/SATA cable, hold the
Keep the removed dummy covers and screws for future use.
Upgrading Your Server 9-45