NEC Express5800 User Manual page 412

9-74 Upgrading Your Server
Installation
Install a CPU in the following procedure. (A part of retention is omitted in the figure below for easy
understanding.)
IMPORTANT:
Handle a CPU after making your body contact with a metallic frame
section of the server to discharge the static electricity on your body. Do
not make bare hands contact with the CPU pins. In addition, do not put
any CPU on a desk directly. See "Static Precautions" for details of the
static electricity.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the following components:
– Side cover
– CPU duct cover
3.
Locate the CPU socket which you are going to install CPU.
4.
Push the lever down to unlatch the socket from the hook, then slowly open the lever until
it stops.
5.
Lift the load plate.
Any CPU is easily affected by static electricity.