NEC Express5800 User Manual page 294

8-16 Troubleshooting
Displayed Error Message
C021 System Voltage out of the
range.
C040 SROM data read error
C041 SROM data checksm bad
C060 SMBus device Error
detected.
C061 1st SMBus device Error
detected.
C062 2nd SMBus device Error
detected.
C063 3rd SMBus device Error
detected.
C064 4th SMBus device Error
detected.
C065 5th SMBus device Error
detected.
C066 6th SMBus device Error
detected.
C101 BMC Memory Test Failed.
C102 BMC Firmware Code Area
CRC check failed.
C103 BMC core hardware failure.
C104 BMC IBF or OBF check
failed.
C105 BMC SEL area full.
Description
A system voltage abnormality
was detected.
SROM data reading error
SROM data checksum error
An error was detected for the
SM Bus.
An error was detected for the 1st
SM Bus.
An error was detected for the
2nd SM Bus.
An error was detected for the
3rd SM Bus.
An error was detected for the
4th SM Bus.
An error was detected for the
5th SM Bus.
An error was detected for the
6th SM Bus.
BMC device (chip) error
Accessing the BMC address
failed.
There is not enough capacity to
write the system event log.
Recommended Action
Contact your service
representative.
Turn off the power, and
then restart the server.
If this does not resolve
the problem, contact
your service
representative.
Start up the BIOS setup
utility, select [Clear All
Error Logs] under
[Event Log
Configuration] on the
[Server] menu, and
then press the Enter
key to delete the logs.