Windows Server 2003 X64 Editions Clean Installation - NEC Express5800 User Manual

Windows Server 2003 x64 Editions Clean Installation

This section explains how to perform a clean installation of Windows Server 2003 x64 Editions.
IMPORTANT:
If you have created the OEM-Disk into the Flash FDD, connect the

Flash FDD before you start the system.
If you have created OEM-Disk into the floppy disk, connect the

USB floppy disk drive before you start the system.
1.
Turn on the system power.
2.
Insert the Windows Server 2003 x64 Edition CD-ROM into the optical disk drive.
3.
Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk drive, press Enter
while the message "Press any key to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk drive, this step is unnecessary.
The Windows Server 2003 x64 Editions setup screen will appear.
If the screen is not displayed, Enter was not pressed properly.
Begin after turning on the system power again.
4.
If the RAID Controller/Option Controller is used, press F6 in a few seconds when the
window is in either of the following states.
– "Setup is inspecting your computer's hardware configuration ..." or "Press F6 if you
need to install a third party SCSI or RAID driver..." is displayed.
– A screen with a solid blue background is displayed.
IMPORTANT:
There is no visible indication on screen when F6 has been pressed.

If the RAID Controller/Option Controller is not used, you do not

need to press F6, and go to Step 12.
5.
When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices.
Installing Windows Server 2003 x64 Editions F-7