Installing Internal Scsi File Device - NEC N8100-1417F User Manual

10-4 Internal Cabling Diagrams

Installing Internal SCSI File Device

To install the internal SCSI file device, you need prepare a separately priced SCSI controller and
SCSI cable.
IMPORTANT:
Up to two SCSI devices can be installed in the server.
To install two half-height SCSI devices in the 5.25-inch device bay,
move the factory-installed optical disk drive to the top bay.
SCSI controller: N8103-75F, N8103-95
SCSI cable: K410-68 internal SCSI cable
K410-68 internal SCSI cable is equipped with terminating resistor. Set "Disabled" for all the
terminating resistors of connected devices. For other setting, refer to the manual provided with the
device.
A file device needs settings such as a SCSI transfer rate. For the transfer rate, see the manual
provided with the file device. Use the BIOS utility of the SCSI controller to make the settings. For
details, see the manual provided with the SCSI controller.
Mother board
PCIe #5
PCIe #4
PCIe #3
PCI #2
PCI-X #1
SCSI controller
K410-68 internal SCSI cable
PCIe #6
Internal RAID
controller
IDE
SAS cable
Terminator
Optical disk drive
IDE cable
(SCSI device)
5.25-inch
(IDE device)
device bay
3.5-inch hard
ID3
disk drive bay
ID2
Hard disk drives
ID1
are optional.
ID0
SCSI cable