NEC Express5800 User Manual page 224

5-90 Installing the Operating System with Express Setup
10.
Uncheck the [Automatically manage paging file size for all drives] box, and check
[Custom size].
11.
On the [Paging file size for each drive] box, specify as follows:
– A value larger than the recommended size shown in [Total paging file size for all
drives] for [Initial size]
– A value larger than the [Initial size] for [Maximum size]
Then click [Set].
IMPORTANT:
The above-mentioned paging file size is recommended for

collecting debug information (memory dump).
The paging file with initial size large enough to store the dump file
in the Windows Partition is required.
Correct debug information might not be able to be collected due to
virtual memory shortage when the paging file is insufficient, so set
an enough size of the paging file with the entire system.
For more information on "Recommended" value, see "About the

System Partition Size" described earlier.
In case the memory is expanded, re-specify the paging file to suit

the new memory size.
12.
Click [OK].
The message to restart the system may appear according to the modified specification.
In such case, follow the message to restart the system.