Installing And Setting Device Drivers - NEC Express5800 User Manual

Installing and Setting Device Drivers

Follow these steps to install and configure the device drivers.
LAN Driver and PROSet
The LAN driver and PROSet have been installed automatically while your system was being
updated in the previous section.
NOTES:
To change the LAN driver and PROSet settings, log on to the

system from a local console using an administrator account.
Remotely changing the settings by using the operating system's
remote desktop feature is not supported.
[Internet Protocol (TCP/IP)] check-box is necessary checked to set

an IP Addresses. According to the circumstances, the check-box is
not checked from begin. Manually checked the check box and set an
IP addresses.
Using N8104-125A Adapter after System Update
To use the N8104-125A Adapter after updating your system, you must first uninstall the LAN driver
and PROSet, and then update your system with the N8104-125A Adapter connected.
 For a server running a full installation
1.
Remove a team of network adapters.
NOTES:
Before you remove, note down the current settings (e.g. IP

addresses) of the standard and optional adapters teamed for network
redundancy.
Configure the settings after reinstalling the LAN driver and

PROSet.
To remove the team, see "Setup Team".

2.
In [Control Panel], click [Uninstall Program].
3.
Double-click [Intel(R) Network Connections 14.8.43.0].
[Intel(R) Network Connections (Remove Options)] appears.
4.
In [Remove Options], click [Remove].
[Intel(R) Network Connections - Remove Software] appears.
Installing the Operating System with Express Setup 5-51