NEC Express5800 User Manual page 424

9-86 Upgrading Your Server
Removal
Remove the DIMM according to the following procedure.
NOTE:
appearing in POST or NEC ESMPRO to identify the DIMM socket in
which the defected DIMM is installed.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the side cover.
3.
Remove the CPU duct cover
4.
Open the levers at the both ends of the socket for the DIMM to be removed.
The lock is released to allow the DIMM to be removed.
5.
Install the components you have removed.
6.
Turn on the power of the server. Make sure that no error message appears in the POST.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
7.
Run the BIOS SETUP and select [Advanced] → [Memory Configuration] → [Memory
Retest] → [Yes] to clear the error information of the removed DIMM. (See Chapter 4 for
details.)
To remove the defected DIMM, check the error message