NEC Express5800 User Manual page 95

Option
Boot Monitoring
[Retry 3 Times]
Policy
Always Reset
Thermal Sensor Disabled
[Enabled]
Check previous Disabled
System Config
[Enabled]
BMC IRQ [IRQ 11]
Disabled
Post Error Pause Disabled
[Enabled]
Memory Error Halt
[Boot]
Power Switch [Disabled]
Inhibit
Enabled
AC-LINK Stay Off
[Last State]
Power On
Power ON Delay [20] - 255
Time (Sec)
Platform Event Disabled
Filtering
[Enabled]
CLI SETUP [Disabled]
Enabled
Parameters
Specify the processing when a timeout occurs
during boot monitoring. This option can only be
specified if [Boot Monitoring] is specified.
If [Retry 3 times] is selected, the system is reset
after the occurrence of a timeout and booting up
the OS is retried up to three times.
If [Always Reset] is selected, the system is reset
after the occurrence of a timeout and booting up
the OS is retried repeatedly.
Specify whether to enable or disable the thermal
sensor monitoring function. If a thermal error is
detected with this item set to [Enabled], the system
stops at the end of POST.
If the system configuration has been changed
since the previous startup, the system waits for
user intervention before booting the system.
Determines routing of the BMC interrupt.
Specify whether to stop the POST once at the end
of POST if an error occurs during the POST.
Specify whether to stop operation once at the end
of POST processing if there is a memory resource
error while executing POST processing. This
setting is effective if [POST Error Pause], which is
on the [Server] menu, is set to [Enabled].
Even if this option is set to [Boot], operation stops
at the end of POST processing if errors occurred
for all resources.
Specify whether to enable or disable the power
switch.
Note that it is not possible to disable the ability to
forcibly turn off the power by holding down the
switch for four seconds.
Specify the state of power when the AC power to
the server is turn off once and then on.
Specify the power on delay time within the range
between 20 and 255 seconds. The time specified
is valid when "Power On" or "Last State" is
specified for AC LINK.
Specify whether to enable or disable the platform
event filtering (PEF) feature.
Set to [Enabled] to run teh CLI SETUP (Command
Line Interface SETUP Menu) instead of SETUP
menu of this GUI. To use the SETUP menu of this
GUI, set this item to [Disabled] on CLI SETUP
menu.
Configuring Your Server 4-25
Description
[ ]: Factory-set