NEC Express5800 User Manual page 223

When the system is Windows Server 2008 R2
Follow the procedure below to specify.
1.
Click Start and select [Control Panel].
The [Control Panel] window appears.
2.
Click [System and Security] and then select [System].
NOTE: If [View by] is not set as [Category], start [System] from
Control Panel directly.
3.
Click [Advanced system settings].
The [System Properties] dialog box appears.
4.
Select [Advanced] tab.
5.
Click [Settings] on the [Startup and Recovery] group box.
6.
Modify [Dump file] in the [Write debugging information] group box, and click [OK].
e.g. Write the debug information in D drive with the file name
"MEMORY.DMP".
D:\MEMORY.DMP
IMPORTANT:
To specify "Complete Memory Dump" to write the debug

information is recommended. If the mounted memory size is larger
than 2GB, "Complete Memory Dump" cannot be specified so that
specify "Kernel Memory Dump" instead.
Specify the drive where there is a free area more than the size of

"the memory capacity mounted on Express server + 300MB".
In case the mounted memory size exceeds 2GB due to the added

memory, change the write debugging information to [Kernel
Memory Dump] before adding memory.
The size of debugging information (memory dump) to be taken also
changes due to adding memory. Verify the size of the empty space
in the debugging information (memory dump) write destination
drive.
7.
Click [Settings] in the [Performance] group box.
The [Performance Options] window appears.
8.
Click [Advanced] tab on the [Performance Options] window.
9.
Click [Change] on the [Virtual memory] group box.
Installing the Operating System with Express Setup 5-89