Configuring Dynamic Link Aggregation
Modifying Dynamic Link Aggregate Group
Parameters
The table on
page 13-3
ware. These parameters ensure compliance with the IEEE 802.3ad specification. For most networks, these
default values do not need to be modified or will be modified automatically by switch software. However,
if you need to modify any of these default settings see the following sections to modify parameters for:
Dynamic aggregate groups beginning on
•
Dynamic aggregate actor ports beginning on
•
Dynamic aggregate partner ports beginning on
•
Note. You must create a dynamic aggregate group before you can modify group or port parameters. See
"Configuring Dynamic Link Aggregate Groups" on page 13-10
Modifying Dynamic Aggregate Group Parameters
This section describes how to modify the following dynamic aggregate group parameters:
Group name (see
•
Group administrative state (see
•
page
13-20)
Group local (actor) switch actor administrative key (see
•
Aggregate Group Actor Administrative Key" on page
Group local (actor) switch system priority (see
•
System Priority" on page
Group local (actor) switch system ID (see
•
ID" on page
13-21)
Group remote (partner) administrative key (see
•
Administrative Key" on page
Group remote (partner) system priority (see
•
Priority" on page
Group remote (partner) switch system ID (see
•
System ID" on page
Modifying the Dynamic Aggregate Group Name
The following subsections describe how to configure and remove a dynamic aggregate group name with
the
lacp linkagg name
Configuring a Dynamic Aggregate Group name
To configure a dynamic aggregate group name enter lacp linkagg followed by the dynamic aggregate
group number, name, and the user-specified name, which can be from 1 to 255 characters long.
OmniSwitch 6600 Family Network Configuration Guide
lists default group and port settings for Alcatel's dynamic link aggregation soft-
page 13-19
"Modifying the Dynamic Aggregate Group Name" on page
"Modifying the Dynamic Aggregate Group Administrative State" on
13-21)
"Modifying the Dynamic Aggregate Group Actor System
13-22)
13-22)
13-23)
command.
Modifying Dynamic Link Aggregate Group Parameters
page 13-23
page
13-28.
for more information.
"Configuring and Deleting the Dynamic
13-20)
"Modifying the Dynamic Aggregate Group Actor
"Modifying the Dynamic Aggregate Group Partner
"Modifying the Dynamic Aggregate Group Partner System
"Modifying the Dynamic Aggregate Group Partner
April 2006
13-19)
page 13-19