Alcatel Interswitch Protocols (AIP) are used to discover adjacent switches and retain mobile port informa-
tion across switches. The following protocol is supported:
Alcatel Mapping Adjacency Protocol (AMAP), which is used to discover the topology of
•
OmniSwitches and OmniSwitch/Routers (Omni S/R). See
In This Chapter
This chapter describes the AMAP protocol and how to configure it through the Command Line Interface
(CLI). CLI commands are used in the configuration examples; for more details about the syntax of
commands, see the OmniSwitch CLI Reference Guide.
Configuration procedures described in this chapter include:
Activating AMAP on
•
Configuring the AMAP discovery timeout interval on
•
Configuring the AMAP common timeout interval on
•
For information about statically and dynamically assigning switch ports to VLANs, see
"Assigning Ports to VLANs."
For information about defining VLAN rules that allow dynamic assignment of mobile ports to a VLAN,
see
Chapter 8, "Defining VLAN Rules."
OmniSwitch 6600 Family Network Configuration Guide
10 Using Interswitch
page
10-5.
Protocols
"AMAP Overview" on page
page
10-5.
page
10-6.
April 2006
10-3.
Chapter 7,
page 10-1