Table of Contents
Advertisement
Configuring Static Link Aggregation
Configuring Static Link Aggregation Groups
This section describes how to use Alcatel's Command Line Interface (CLI) commands to configure static
link aggregate groups. See
more information.
Note. See
"Quick Steps for Configuring Static Link Aggregation" on page 12-3
configuring these mandatory parameters.
Alcatel's link aggregation software is preconfigured with the default values for static aggregate groups as
shown in the table in
of these parameters, please see
information.
Note. See the "Link Aggregation Commands" chapter in the OmniSwitch CLI Reference Guide for
complete documentation of CLI commands for link aggregation.
Configuring Mandatory Static Link Aggregate Parameters
When configuring static link aggregates on a switch you must perform the following steps:
1
Create the Static Aggregate Group on the Local and Remote Switches. To create a static aggregate
group use the
static linkagg size
Aggregate Group" on page
2
Assign Ports on the Local and Remote Switches to the Static Aggregate Group. To assign ports to
the static aggregate group you use the
Deleting Ports in a Static Aggregate Group" on page
Note. Depending on the needs of your network you may need to configure additional parameters.
Commands to configure optional static aggregate parameters are described in
tion Group Parameters" on page
OmniSwitch 6600 Family Network Configuration Guide
"Configuring Mandatory Static Link Aggregate Parameters" on page 12-7
"Static Link Aggregation Default Values" on page
"Modifying Static Aggregation Group Parameters" on page 12-15
command, which is described in
12-8.
static agg agg num
12-15.
Configuring Static Link Aggregation Groups
12-2. If you need to modify any
"Creating and Deleting a Static Link
command, which is described in
12-9.
April 2006
for
for a brief tutorial on
for more
"Adding and
"Modifying Static Aggrega-
page 12-7
Hide quick links:
Advertisement
Table of Contents
