Alcatel OmniSwitch 6600 Family Network Configuration Manual page 68

Configuring MAC Address Table Aging Time
Note. The MAC address table aging time is also used as the timeout value for the Address Resolution
Protocol (ARP) table. This timeout value determines how long the switch retains dynamically learned
ARP table entries. See
To set the aging time back to the default value, use the no form of the mac-address-table aging-time
command. For example, the following sets the aging time for VLAN 255 (for all VLANs if VLAN ID is
not specified) back to the default of 300 seconds:
-> no mac-address-table aging-time vlan 255
To display the aging time value for one or all VLANs, use the
command. For more information about this command, see the OmniSwitch CLI Reference Guide.
page 2-8
Chapter 14, "Configuring IP,"
OmniSwitch 6600 Family Network Configuration Guide
for more information.
show mac-address-table aging-time
Managing Source Learning
April 2006